HM-10 High Quality Bluetooth Module Clone

HM-10 High Quality Bluetooth Module CloneDescription The HM 10 Bluetooth module combines the powerful and programmable Texas Instruments CC2541 Chipset with the required components to start right away with your BLE development. The module offers an on board voltage regulator and is TTL level and 5 V tolerant. The Bluetooth SoC can be accessed via UART interface and supports AT Commands for setup. It supports full Bluetooth 4. 0 standard and can be used for your Arduino or microcontroller to

Water sensing purposes

A unique tool to strip & cut insulation on copper wire ranging from 0

Dual Micro USB 3

The Lora Module Ra-02 is a wireless transmission module based on SEMTECH SX1278 wireless transceiver

The Raspberry Pi 3 Model B+ maintains the same mechanical footprint as both the Raspberry Pi 2 Model B and the Raspberry Pi 3 Model B

1 x SE 586 (HT-3) 30A Block Connector

The CH340 USB-to-serial chip ensures stable USB communication and wide driver support across Windows

pcb testing breadboard

Identity authentication

This keeps the pin layout intact and allows another shield to be stacked on top

Pressure applied =0

5 mm or 6 mm diameter